Holy crap, that’s a lot of work to get a roll of filament. That’s only economical if your time is worth nothing. Ugh.

  • FuglyDuck
    link
    fedilink
    English
    3
    edit-2
    9 months ago

    Not to be like that… but… gases would be hard to print, I’m not sure why you’d want to….

    Liquids could be interesting, for like, ice sculptures. But at that point you’d be having to extract heat from ambient… drop the build chamber below freezing

      • FuglyDuck
        link
        fedilink
        English
        18 months ago

        Eh. That could work, might be more complicated though.

        I’m envisioning a freezer for an enclosure, then heat the water to just above melting. This would allow using essentially-fdm set ups on the printer itself.