I’ve been tuning to print at a 0.1mm layer height, the ironing turned out like this. The left side of the Z is a little textured and more shiny.
Why did this happen and how could I fix it?
You must log in or register to comment.
Try monotonic order on top player. I never tried it with ironing, but its worth a shot
That looks like the issue to me as well, good call.
i don’t know much about 3D printing, but it looks like a bit of fine sand paper and then ironing again could fix it.
Ironing is a 3d printing term where the heated nozzle is used to smooth the final layer, it’s not about taking an actual iron to your print.
The print shown is a calibration cube, meant to show you the results of your print settings so you can adjust them to get better prints.