AppearanceBoring9229@sh.itjust.works to 3DPrinting@lemmy.worldEnglish · 1 年前bought a glass too small for my fridge so I fixed it 3d printingsh.itjust.worksimagemessage-square17linkfedilinkarrow-up146arrow-down10
arrow-up146arrow-down1imagebought a glass too small for my fridge so I fixed it 3d printingsh.itjust.worksAppearanceBoring9229@sh.itjust.works to 3DPrinting@lemmy.worldEnglish · 1 年前message-square17linkfedilink
minus-squareAppearanceBoring9229@sh.itjust.worksOPlinkfedilinkEnglisharrow-up2·1 年前Had to make a second version because the one on the post was too fragile. It was bending with just the glass. The new one looks like this
minus-squaretechnomad@slrpnk.netlinkfedilinkEnglisharrow-up2·1 年前Oh, nice fit! Are you pretty satisfied with it so far? I don’t imagine it would have any issues with the cold temps, and it pretty much looks like it came with the fridge. Good work!
minus-squareAppearanceBoring9229@sh.itjust.worksOPlinkfedilinkEnglisharrow-up2·1 年前Yes, it looks better than I expected. I will seal it later to prevent bacterial growth as someone suggested here
Had to make a second version because the one on the post was too fragile. It was bending with just the glass. The new one looks like this
Oh, nice fit! Are you pretty satisfied with it so far? I don’t imagine it would have any issues with the cold temps, and it pretty much looks like it came with the fridge. Good work!
Yes, it looks better than I expected. I will seal it later to prevent bacterial growth as someone suggested here