Yes in my experience, ABS is an easier print.

For ASA, I think maybe Sainsmart. They also do bad tpu, so maybe source was the problem.

How do you handle fumes with ASA? they are much worse than ABS, imo.

Hey! I was thinking about doing this.

Any useful info, should o give it a go?

Essentially. I was growing oregano, basil, flowers, and thyme in others.

Printed right side up. Everything was achieved via support setting optimization, and heated support removal where necessary (nose and lip in particular).

PLA holds up alright, but it’s gets brittle. There are just better choices.

Interesting point about the ABS, it appears to be holding up very good, but I’ll monitor it overtime.

ABS is nice, PETG good, ASA hard to print, PLA holds up(but don’t recommend).

deleted by creator

That’s kinda my understanding as well.

Brave/Firefox, although basically reskins, help keep ads at bay.

Kinda Brave/firefox can keep a lot of ads from bogging down things.

Damn. Cuts deep

Have at. Ethical limitations apply as it’s a fairly new technology.

That’s a good take

This is my favorite comment btw. You win the thread

Interesting. Thanks for this

What a rude thing to say

Touch grass my European friend

Humans are overpopulated killing machines responsible for multiple extinctions….

I suppose you’re right.

I doubt I want to deal with a dead bird anyway.

You win the wisdom award. At least until I get bored and look up bird population parasite/diseases more in depth. Which I am unlikely to do.

No. Just no. Even prisoners are allowed outdoor privileges.

They’re interested, it’s a contained area, they are supervised. No.

I’ll counter with. I have a vet. I am interested in birdwatching and the cats are only outside supervised.

Good points.

I agree here. What if the bird population wasn’t endangered and considered a pest?

To be clear this is hypothetical. I haven’t done anything.