I think I know precisely what you mean
I think I know precisely what you mean
The Donner party were a group on the Oregon trail that got stuck on a mountain pass in the winter and resorted to cannibalism to survive. The Dollup did a really good podcast episode about it.
Also the cafe in the University of Colorado UMC is named “The Alfred Packer Gill”. Alfred Packer was a similar famed cannibal.
looks like the female end of a crimp on bullet connector
They are typical as low-point drains and manifold drains, both on the main line (always charged). Don’t just cap it if that would make a dead end, especially if it’s sloped down to drain. I can’t tell very well from the picture, but if it’s on a tee you would be okay putting in a threaded cap.
“king drains” or auto drains are common. A short nipple and either a brass cross-top or pvc ball valve would be better. Just be sure that it is accessible in the end.
That soundtrack still slaps.
Hollow doors have about a 1" frame of solid wood around the perimeter.
If the door frame is not currently falling out of the opening there’s enough meat in the opening to mount a new one. Fondots is right. Re mortising well for the hinges and modifying the door to fit will be more effort than getting a pre-hung.
Picture looks like real wood and not paper, hardie or vinyl. Venat0r has the right idea of taking a sample in to your local yard. A couple possibilities I came across online are https://www.becn.com/products/siding/wood-siding/C-503734 and https://truwoodsiding.com/products/1-2-cedar-shake-lap-siding/ although the online pictures are garbage for them.
then he said
No, not that one. The bad one
folding stool
I thought that only happened to cats
He’s gonna cry himself to sleep on his huge pillagh!
If lemmy was the entire EU voting block the world would be a very different place. It’s not encouraged here, but here is not the entire EU.
in other news, Charelston PD announces their new MH-139A helicopter
In USA I usually get Printed solid’s Jesse and 3D Printing Canada’s Budget PLA. I also pick up a couple rolls of Inland any time I’m by my local Microcenter
Filament sourcing is pretty region specific. Where are you buying from?
I just want to scritch their cute memoryfoam heads.
This might’ve hurt too.
easy peasy. just lift the 100 kilo chunk of iron with some tongs. /s
I also always have a sharpie on me and often use it to fix the missing labels on these pumps.
A thin layer of glue stick kept petg from bonding to glass for me, but a nice thick layer of G10 is better as long as you heat soak it before printing. I roughed mine up with some sandpaper and haven’t had any issues. Just remember good ppe when working with fiberglass.