• k5nn@lemm.ee
    link
    fedilink
    arrow-up
    28
    arrow-down
    7
    ·
    1 year ago

    Inb4 apple places a chip in the cable that only handshakes with apple devices?

    • gila@lemm.ee
      link
      fedilink
      arrow-up
      8
      arrow-down
      1
      ·
      1 year ago

      It’s the ports, they force USB2.0 speeds (same as lightning) unless you get the Pro (this is unverified)

      • SirQuackTheDuck@lemmy.world
        link
        fedilink
        arrow-up
        4
        ·
        1 year ago

        they force USB2.0 speeds (same as lightning) unless you get the Pro (this is unverified)

        Not as much force, it’s just the chip in there isn’t good.

        It’s very verified by the way, it’s in the Tech Specs.

        IPhone 15: usb 2 to 480 Mbps (source)
        IPhone 15 Pro: usb 3 up to 10 Gbps (source)

      • k5nn@lemm.ee
        link
        fedilink
        arrow-up
        1
        arrow-down
        1
        ·
        edit-2
        1 year ago

        Wait so if it’s not apple’s cable you’re throttled to usb 2.0 speeds?

        • gila@lemm.ee
          link
          fedilink
          arrow-up
          4
          ·
          1 year ago

          Nothing to do with the cable, the port on the device is a USB-C port that is limited to USB2.0 speeds. Whereas the iPhone Pro has one that can do USB3.0 speeds. This seems to have been recently verified by the tech specs on Apple website btw

        • Andrenikous@lemm.ee
          link
          fedilink
          English
          arrow-up
          2
          ·
          1 year ago

          No, only the iPhone 15 pro has usb3. iPhone 15 is usb2. They have it listed that way on their site.

    • Dave@lemmy.nz
      link
      fedilink
      arrow-up
      7
      arrow-down
      1
      ·
      1 year ago

      Didn’t some early 2000s Mac USB cables have a bit sticking out and a notch on the computer so they could only be used with Macs?

      • m3t00🌎@lemmy.world
        link
        fedilink
        English
        arrow-up
        3
        ·
        1 year ago

        incompatible monitor/printer cables… they all had ‘standards’. whatever happened to ISA or parallel

      • Asymptote@lemmy.dbzer0.com
        link
        fedilink
        arrow-up
        3
        ·
        1 year ago

        Compliance reasons. USB spec at the time didn’t really allow for extension cables because it added an unknown amount of resistance.

        The notch was a workaround; they were within spec for the intended device both with and without that cable.