I liked a few of the VSOs that were posted earlier and wanted to share two of my more recent creations.
This mount screws into an exposed 2x4 and lets me get my Synology DS418, its power brick, and UPS (APC BE600M1) off a table and into a lower dust area of my basement.
I’ll upload the STLs to printables if anyone is interested, but be warned that the parts are fairly large.
In the spirit of showing parts under unflattering lighting, here’s (nearly) the same angle with a different light source.
I think it looks fine, the layers are aligned appropriately and it seems at least 5mm thick
I disagree. It seems that the letters are along where the stress is, which can eventually cause determination. This part scares me when you consider how important what it’s holding it’s.
layers
delamination?
is